SD-WAN tab

Updated on 18 Apr 2023
1 Minute to read

Print
Dark
Light
PDF

Article summary

Did you find this summary helpful?

Thank you for your feedback

This shows configured underlay and overlay paths of SD-WAN tunnels.

Path status conditions are:

Normal (no issue related to SD-WAN)
Warning (SLA metrics are violated)
Error (path is down)

This only displays path information if SD-WAN is enabled. To verify, go to Network :: SD-WAN :: Settings and ensure Enable SD-WAN checkbox is selected. If disabled, warning message states:
SD-WAN must be enabled.

If topology is not yet configured inside the device, the following message displays:
No information to be displayed.

NOTE:

This message is also displayed on overlay tab from Hub device. SD-WAN does not measure overlay paths inside Hub.

If there is an error communicating with the SD-WAN daemon, the following message displays:
Failed to communicate with SD-WAN daemon. Please reload.

On the CLI, go to /system/sdwan/ directory and use show command to display details.

The values displayed under columns of latency, jitter, and packet loss; are the average and the threshold for each metric.

Was this article helpful?

What's Next

Underlay sub-tab