Configure Sensor Settings on Nodegrid Device

To perform these procedures, log into the Nodegrid Device.

Access sub-tab

1. Go to Managed Devices :: Devices :: Relay :: Access. 
2. As needed (many of these are optional):
   1. On Type drop-down, accept default: USB_sensor.
   2. Enter Address Location.
   3. Enter Coordinates (Lat,Lon).
   4. Click Icon (on pop-up, select the preferred icon)
   5. On Mode drop-down, select one (Enabled, On-demand, Disabled, Discovered).
3. Click Save.

Management sub-tab

1. Go to Managed Devices :: Devices :: Relay :: Management. 
2. In the Monitoring menu, select Nominal checkbox (expands dialog).
   1. Enter Name.
   2. On Type drop-down, select one. 
   3. Enter Value.
   4. Enter Interval (seconds).
3. In the Scripts menu (if scrips are available): 
   1. On Run on Session Start drop-down, select a script.
   2. On Run on Session Stop drop-down, select a script.
   3. On Run on Device UP drop-down, select a script.
   4. On Run on Device Down drop-down, select a script.
4. Click Save.

Custom Fields sub-tab

1. Go to Managed Devices :: Devices :: Relay :: Custom Fields. 
2. To create a custom field, click Add (display’s dialog). 
   1. Enter Field Name.
   2. Enter Field Value.
3. Click Save.

Commands sub-tab

1. Go to Managed Devices :: Devices :: Relay :: Commands. 
2. To create a custom command, click Add.
3. In Command drop-down select one (Web, Custom Commands).
   1. Select Web (displays dialog). Select Enabled checkbox.
      Enter WEB URL.
   2. Select Custom Commands (displays dialog). Select Enabled checkbox.
      In Script drop-down, select one. Select Enabled checkbox. Enter Command Label.
4. (Repeat as needed)
5. Click Save.

Sensor Channels sub-tab

The table displays configured sensor channels.

1. Go to Managed Devices :: Devices :: Relay :: Sensor Channels. 
2. To edit channel details, click on name (displays dialog).
3. Click on Smoke_Alarm channel (displays dialog). 
   1. Edit Name (as needed).
   2. On Mode drop-down, accept default: relay.
   3. On Unit drop-down, accept default: Off/On.
4. Click on Front_Door_Lock channel (displays dialog). 
   1. Edit Name (as needed).
   2. On Mode drop-down, accept default: relay.
   3. On Unit drop-down, accept default: Off/On.
5. Click on Rear_Door_Lock channel (displays dialog). 
   1. Edit Name (as needed).
   2. On Mode drop-down, accept default: relay.
   3. On Unit drop-down, accept default: Off/On.
6. Click on Relay_cn3channel (displays dialog). 
   1. Edit Name (as needed).
   2. On Mode drop-down, accept default: relay.
   3. On Unit drop-down, accept default: Off/On.
7. Click Save.